
Takes 30 seconds. We call you back to set a time.
Wayne Dalton is one of the best known garage door brands in America, and its doors are on homes all over Long Island, Queens and Brooklyn. The range runs from simple steel doors for detached garages to heavily insulated doors, carriage designs and modern full-view glass. We install new Wayne Dalton doors and service the ones already on your home. Free estimate at (929) 429-2429.
By Sean Cohen, owner, On Point Garage Doors · Updated
These photos are from our own jobs, with our logo on them.



Wayne Dalton offers doors from single-layer steel to thick insulated doors. For attached garages, garages under bedrooms and heated workshops, an insulated door keeps the space more comfortable and makes the door stiffer and quieter.
For detached garages that are not heated, a lighter door is often enough. The technician helps you decide based on how you use the space.
The right door depends on the house: a carriage design suits colonials and Tudors, a raised panel suits most capes and ranches, and a flush or glass door suits modern homes. Color matters too: matching the trim or the front door makes the house look put together.
We bring samples and show you photos of doors like yours, so the choice is easy to picture.
Many Wayne Dalton doors use the TorqueMaster spring system, with the springs inside a tube above the door. Others use standard torsion springs. New doors come with springs sized to their weight. On existing doors, we repair TorqueMaster systems or convert them to standard springs.
The old door, its tracks and its springs come out and leave with the technician. The new door goes in with new tracks, new springs sized to it, new rollers, new hinges and new seals. The frame is checked for rot and square, and the opener is set to the new door, or replaced if you choose.
Before leaving, the door is balanced, run several times and the safety reverse is tested.
We fix broken springs, frayed cables, worn rollers, cracked hinges, dented panels and bad seals on Wayne Dalton doors. When a panel is damaged, a matching replacement section may be available depending on the model and age. When it is not, a new door is explained with a free estimate. Faults that belong to this brand, from split hinge holes to matched joints, are set out under Wayne Dalton garage door repair.
On homes by the bay and the canals, salt air is hard on steel. Wayne Dalton doors with a good factory finish and rust-resistant hardware hold up well. The bottom section and its seal take the most water and are worth watching.
A new insulated door may be heavier than the one it replaces, and the opener has to be matched to it. If your opener is old, loud or has no safety sensors, replacing it with the door gives you a quiet, connected system that starts fresh together.
Many homes here have one wide door for two cars, others have two single doors. Two singles let each car in and out on its own and keep more warmth in when only one is open; one double door gives a wider opening. Where the framing allows, we can talk through changing from one to the other.
The technician measures the opening, the headroom and the side room, checks the frame and the opener, and shows you the Wayne Dalton styles and options that fit, with a free estimate for each.
Many homes have an original Wayne Dalton door that has served for years and is now dented, faded or worn at the bottom. A new door brings modern insulation, quieter operation and a fresh look, and the new springs, tracks and rollers start the whole system over.
If you liked the old door, we can usually find a current style that looks close to it, or show you something new.
Wide double doors on open lots and near the water take a lot of wind. Doors built with stronger struts and heavier hardware hold up better and stay quieter in gusts. The technician points out where that matters on your street.
A new door needs little: rinse road salt off the bottom section after winter, keep the bottom seal in good shape, and have the springs, rollers and opener checked once a year. That keeps the door balanced and quiet for many years.
Yes. We install new Wayne Dalton doors and service existing ones across Brooklyn, Queens and Long Island.
Yes. They are widely used, available in many styles and insulation levels, and parts are easy to find.
Many use the TorqueMaster system, with springs inside a tube. Others use standard torsion springs. We service both.
Sometimes, depending on the model and age. If not, we give you a free estimate on a new door.
Yes. You see the styles and options that fit before any work starts.
Across Brooklyn, Queens and Long Island, tell us what the door is doing and we set a visit that fits your day.
Free estimate, call (929) 429-2429.
Tell us what the door is doing and we will give you an honest arrival time. The estimate is free.
Easier to explain by phone? Call (929) 429-2429.
Tell us what the door is doing. The estimate is free either way.