
Takes 30 seconds. We call you back to set a time.
On a new home, an addition or a gut renovation, the garage door is one of the last things installed and one of the first things people see. Getting it right starts much earlier: the rough opening, the header, the headroom and the electrical for the opener all decide which door fits and how well it works. We work with builders, contractors and owners across Brooklyn, Queens and Long Island to plan and install the door at the right time. Free estimate at (929) 429-2429.
By Sean Cohen, owner, On Point Garage Doors · Updated
These photos are from our own jobs, with our logo on them.



The rough opening width and height, the headroom above the opening, the side room on each side and the depth of the garage all affect which doors and tracks fit. Planning them with the door in mind avoids filler boards, low-headroom compromises and doors that look squeezed.
The opener needs an outlet on the ceiling near where the motor will hang, or beside the door for a wall-mounted opener. The wall control and sensors need low-voltage wiring runs. Planning those before the drywall goes up keeps the install clean, with no wires stapled across finished walls.
The garage door should be chosen along with the windows, siding and front door, not after. Long panels make a wide house look calmer, carriage designs suit traditional homes, and full-view glass suits modern ones. Color and window patterns tie the facade together.
On new homes the garage is often attached and sometimes under living space. An insulated door keeps the garage and the rooms around it comfortable, cuts noise and suits the energy goals of a new build.
The door usually goes in after the opening is framed and finished on the outside, and before the driveway is complete. We coordinate with the builder so the door is ordered in time and installed when the site is ready, and the opener once power is on.
When an old garage is rebuilt, enlarged or turned into living space with a new garage beside it, the same planning applies. Older openings are often resized, and the header may need to be upgraded to carry a modern spring system.
Two-family homes, small apartment buildings and mixed-use projects often have shared garages with heavier use. Doors, springs and operators are chosen for the number of daily cycles, and access control for many residents is planned.
The door, tracks, springs sized to the door, rollers, hinges and seals are installed, the door is balanced, and the opener is installed and set up with sensors, wall control, remotes and the app. The safety reverse is tested before handover.
Send the plans or the opening sizes, or have the technician visit the site. You get a free estimate with door and track options that fit the opening, and advice on framing and electrical if it is not done yet.
The most common problems on new homes are a header that is too thin for the spring bracket, an opening framed slightly out of square, no outlet on the ceiling for the opener, and a slab that slopes toward the door. Each is easy to fix early and hard to fix once the drywall, siding and driveway are finished.
Many new homes here are built on narrow lots with a garage at the front and very little side room. The vertical tracks and spring brackets need space beside the opening, so side room is planned with the framing. Where space is very tight, special hardware can be used.
When the job is finished, the owner gets the remotes, the keypad code, the app set up on their phone and a quick walk-through of the emergency handle, the lock and the safety reverse. That way the new house is ready to use from day one.
Sometimes the site needs to be secured before the final door arrives. The opening can be closed with a basic door or the final door can be installed early and protected, depending on the schedule. We plan that with the builder so the garage is not left open.
Once the rough opening is framed and confirmed, so the door arrives when the site is ready.
A solid header, plumb and square jambs, enough headroom and side room, and a level slab at the opening.
On the ceiling near where the motor will hang, or beside the door for a wall-mounted opener.
Yes. We coordinate the order and install with the build schedule.
Yes. You get door and track options and an estimate before anything is ordered.
Across Brooklyn, Queens and Long Island, tell us what the door is doing and we set a visit that fits your day.
Free estimate, call (929) 429-2429.
Tell us what the door is doing and we will give you an honest arrival time. The estimate is free.
Easier to explain by phone? Call (929) 429-2429.
Tell us what the door is doing. The estimate is free either way.