
Takes 30 seconds. We call you back to set a time.
Marantec is a European opener maker known for quiet, smooth belt-drive openers, and its units are installed in many garages across Long Island, Queens and Brooklyn, often by door dealers alongside a new door. We repair Marantec openers, pair their remotes and keypads, and replace units when that is the better choice. Free estimate at (929) 429-2429.
By Sean Cohen, owner, On Point Garage Doors · Updated
These photos are from our own jobs, with our logo on them.



Many Marantec units show a code or a light pattern when something is wrong, such as a sensor problem, a force limit reached or a travel issue. If you tell us what the opener is showing, we can often narrow down the cause before the visit.
Like every modern opener, Marantec units refuse to close the door when the safety sensors are blocked or out of line. Sensors knocked by bikes or bins, blinded by sun or with pinched wires are the most common reason a door will not close. They are reset, protected or replaced.
Marantec's belt-drive openers are designed to be quiet, which suits garages under bedrooms. If a Marantec has become noisy, the cause is often the door rather than the opener: worn rollers, dry hinges or tired springs. Fixing the door usually brings the quiet back.
A Marantec that strains, slows or reverses may be fighting a heavy door with weak springs. Before any opener part is replaced, the door is disconnected and its balance tested by hand.
Marantec remotes and keypads pair with Marantec openers. After a power surge, a new board or a lost remote, pairing may need to be done again, and lost remotes should be cleared from memory. Car buttons can often be paired too, sometimes with an adapter.
Sensors, wall controls, remotes, drives and boards can often be replaced. If a part is no longer available or the unit is old and worn in several places, a new opener is explained with a free estimate. A new opener can add phone control and battery backup.
Many openers, including some Marantec models, offer battery backup so the door works during power outages. Old batteries weaken and should be replaced every few years. A beeping opener often means the battery needs attention.
The technician identifies your Marantec model, tests the door's springs and balance, checks the sensors, the drive, the board, the remotes and the wall control, explains what is wrong with a free estimate, and after the repair sets the travel and force and tests the safety reverse.
We also repair and install LiftMaster, Chamberlain, Genie, Craftsman, Linear and other openers. If you are replacing an old opener, we can show you options from several brands that fit your door.
Many Marantec openers were installed by a door dealer at the same time as a new door. If that door has since had panels, windows or insulation added, or the springs have aged, the opener may now be working harder than it should. Balancing the door often fixes a Marantec that has started to strain.
Many Marantec units have built-in lights. When the light stays off or flickers, the cause may be the light module, the board or a setting. The light circuit is checked along with the rest of the opener.
When two doors each have a Marantec opener, remotes and keypads can be set to open one door or both. Each door is set up and tested so the buttons open the door you expect.
Owners often chose a Marantec for its quiet belt drive in a garage under a bedroom. Keeping it quiet means keeping the door quiet too: sealed rollers, sound hinges, a balanced door and a solidly mounted rail. Those are checked on every visit.
When an older Marantec reaches the end of its life, a new quiet belt drive or a wall-mounted opener keeps the garage just as calm. The old unit and rail are removed, new sensors and a wall control are wired, and remotes, keypad and app are set up.
Many cars pair with Marantec openers directly; others need a small adapter. Each car button is tested before the technician leaves.
Quiet belt drives from several makers suit garages under bedrooms.
Yes, including their sensors, drives, boards, remotes and keypads.
Usually the safety sensors are blocked, dirty, out of line or wired badly.
Often the door is the cause: worn rollers, dry hinges or weak springs.
Yes. Marantec remotes and keypads can be paired, and lost ones cleared from memory.
Yes. You see what is wrong and the options before any work starts.
Across Brooklyn, Queens and Long Island, tell us what the door is doing and we set a visit that fits your day.
Free estimate, call (929) 429-2429.
Tell us what the door is doing and we will give you an honest arrival time. The estimate is free.
Easier to explain by phone? Call (929) 429-2429.
Tell us what the door is doing. The estimate is free either way.