
Takes 30 seconds. We call you back to set a time.
A roll-up door is built from narrow metal slats that coil around a drum above the opening as the door rises. Because it rolls up into a compact coil instead of sliding back under the ceiling, it leaves the whole garage ceiling free. Roll-up doors are the standard on storefronts, storage units and warehouses, and they also suit some homes, sheds, workshops and garages with no room for overhead tracks. Free estimate at (929) 429-2429.
By Sean Cohen, owner, On Point Garage Doors · Updated
These photos are from our own jobs, with our logo on them.



The slats run in guides on each side of the opening. Above the opening, a barrel with springs inside it balances the door, and the curtain wraps around it. Smaller doors are lifted by hand with the springs doing most of the work; larger ones use a chain hoist or a motor.
Roll-up doors that are hard to lift have springs that have lost tension. Doors that drop on their own have springs that are too weak or broken. Doors that drag or jam usually have a bent slat, a bent bottom bar or dirt and rust in the guides. Locks seize from rust. All of these are routine repairs.
The springs of a roll-up door sit inside the barrel above the opening and hold strong tension. Adjusting or replacing them is a job for a trained technician, because releasing that tension the wrong way can cause serious injury.
Hand-lifted roll-ups can often take a motor, which makes a heavy door easy to use every day and adds remote or keypad control. The door must be balanced and moving freely first, so the motor does not strain.
Bottom bars, guides and the lowest slats take the most water and road salt. Rust there makes a door stiff and noisy, and eventually it jams. Rust-resistant finishes and a good bottom seal help a roll-up door last, especially near the water.
A roll-up door with a strong bottom bar and a proper lock is very secure. Slide bolts into the guides, center locks and padlock points are options. A motorized door holds itself closed when the motor is off.
Spring tension and replacement, bent slats, new bottom bars, guide repairs, new seals, locks and motors. Doors that have been patched many times get a straight answer on whether another repair is worth it.
The technician measures the opening and the space above it, checks the guides and the structure, and explains whether a roll-up or a sectional door suits your garage best, with a free estimate for each.
Salt air attacks the slats, the guides and especially the springs inside the barrel. On homes and businesses near the bay and the canals, galvanized and coated roll-up doors last much longer, and a yearly check of the springs and bottom bar catches rust before it jams the door.
Some roll-up doors are made with insulated slats. They are warmer and quieter than plain slats, though usually still not as tight as an insulated sectional door. For a workshop that is heated in winter, an insulated roll-up can be a good compromise when the ceiling must stay clear.
Larger roll-up doors are often raised with a hand chain hoist. When the chain gets hard to pull, the springs have usually lost tension or the guides are binding. Forcing the chain only wears the hoist. The door is balanced and the guides cleared so it moves easily again.
We also repair roll-up doors on storage units, warehouses and shops, and the rolling security gates in front of storefronts. Those see much heavier use than home doors, and their springs, bottom bars and motors are sized for it.
The heavier commercial versions have their own pages: rolling steel door repair, storefront gate motors and fire-rated rolling doors.
Roll-up doors rumble as the slats coil and uncoil, and they get louder when the guides are dry, dented or full of grit. Clearing the guides, straightening bent slats and setting the spring tension so the door is not slamming into its stops makes a roll-up door far quieter.
Many roll-up doors lock with slide bolts into the guides or a padlock through the bottom bar. When those seize from rust, the door cannot be secured. New locks are installed and lined up with the guides.
A door of narrow metal slats that coils around a drum above the opening as it rises.
They suit garages that need the ceiling free, sheds and workshops. Sectional doors offer more styles and better insulation.
Usually the springs inside the barrel have lost tension. A technician resets or replaces them.
Often yes, once the door is balanced and moving freely.
Yes. You see the options that fit before any work starts.
Across Brooklyn, Queens and Long Island, tell us what the door is doing and we set a visit that fits your day.
Free estimate, call (929) 429-2429.
Tell us what the door is doing and we will give you an honest arrival time. The estimate is free.
Easier to explain by phone? Call (929) 429-2429.
Tell us what the door is doing. The estimate is free either way.