
Takes 30 seconds. We call you back to set a time.
A garage built for sedans can be a tight squeeze for a lifted pickup, a high-roof work truck, an SUV with a roof box or a small camper. Sometimes the problem is the opening itself; sometimes it is the door hanging too low when open, or the opener stopping the door short. There are several ways to gain clearance, and the right one depends on your garage. Free estimate at (929) 429-2429.
By Sean Cohen, owner, On Point Garage Doors · Updated
These photos are from our own jobs, with our logo on them.



The three measurements that decide all this are explained on the garage door clearance page.
Often the simplest gain is making sure the door opens all the way. Openers set to stop a little early, or doors that stop short because of weak springs, take away valuable inches. The springs are checked and the travel set so the door clears the opening completely.
In garages with a taller ceiling, high-lift track runs the door up the wall before it turns, so the open door sits near the ceiling instead of just above the opening. That frees the space a tall vehicle needs. It needs new track, drums, cables and springs matched to the door.
A wall-mounted opener sits beside the door, so there is no rail or motor in the middle of the ceiling. With high-lift track, it is the usual way to clear the space overhead completely.
More on when one fits, and when it does not, is on the wall-mount garage door opener page.
When the framed opening itself is too low, raising it is a framing job: a new header and taller jambs, then a taller door. It depends on what is above the opening and is checked carefully before anything is planned.
A taller opening usually means a door built to size, which is what the custom garage doors page is about.
Large vehicles also need width. Changing two single doors to one wide door, or widening a single opening, gives more room to drive in straight. Both need the header checked or replaced to span the wider opening.
What changes on a wide door (springs, struts, opener) is covered under oversized garage doors.
With a tall vehicle, the photo eyes still sit near the floor, and the door must reverse if it touches the roof. The reverse is tested carefully after any change. Ceiling lights may need to move so the open door and the vehicle clear them.
Tradespeople who park work trucks at home, and small businesses with a truck bay, often need more height. The same options apply, and on commercial doors, operators sized for daily use are installed.
Small campers and boat trailers with tall bows need even more clearance. Sometimes a taller opening and door is the only answer. The technician measures the vehicle and the garage together.
The technician measures your vehicle and the garage, the opening, the headroom and the ceiling, checks the springs and opener, and explains which options give you the clearance you need, with a free estimate for each.
Until the clearance is fixed, wait until the door is fully open before driving in, and never drive under a door that is moving. A car roof that hits a door can bend sections and damage the opener.
Measure the vehicle's height with the roof box or rack on, and add a little room for the suspension and the slope of the driveway. The technician compares that with the opening and with where the open door and the opener sit.
On a driveway that slopes up or down to the garage, a tall vehicle tilts as it enters, and its roof can come closer to the door than the measurements suggest. That is taken into account when planning the clearance.
Doors with heavy window sections or decorative overlays need the right springs and track to rise fully. When clearance is tight, every inch of travel counts, so the door is balanced and the travel set to the very top.
With a tall vehicle passing under the door, the opener's force and reverse are set carefully. If the door ever touches the roof while closing, it must stop and go back up at once.
Roof racks with bikes or kayaks add a lot of height. A note by the wall button, or a hanging marker from the ceiling, reminds drivers to unload before pulling in.
Two tall vehicles side by side may need both height and width changed together.
On the one-door-or-two question, see a double door versus two single doors.
Set the door to open fully, add high-lift track and a wall-mounted opener, or raise the opening.
Track that runs the door up the wall before turning, so the open door sits high near the ceiling.
Sometimes. It needs a new header and taller door, depending on what is above.
Yes. It removes the rail and motor from the middle of the ceiling.
Yes. You see the options before any work starts.
Across Brooklyn, Queens and Long Island, tell us what the door is doing and we set a visit that fits your day.
Free estimate, call (929) 429-2429.
Tell us what the door is doing and we will give you an honest arrival time. The estimate is free.
Easier to explain by phone? Call (929) 429-2429.
Tell us what the door is doing. The estimate is free either way.