
Takes 30 seconds. We call you back to set a time.
These photos are from our own jobs, with our logo on them.



Raynor and Overhead Door garage door repair in Brooklyn, Queens and Long Island, with a free estimate. Both makers sell mostly through local door dealers, so their doors tend to be solid and properly installed. When one stops working, it is usually a part that has worn out, not the door itself.
By Sean Cohen, owner, On Point Garage Doors · Updated
Overhead Door is the company behind the first upward-acting garage door. Raynor has built doors for a long time too, and it shows up on a lot of houses and commercial buildings here. Both brands are sold mainly through door dealers, so the doors we meet were usually measured and hung by a door company, not a weekend project.
That is good news for repair. A door that was sized and balanced properly at the start has fewer hidden problems. What fails is what fails on every sectional door after enough years: springs, cables, rollers, hinges and the bottom section.
Overhead Door Corporation also owns Genie. So the opener above an Overhead Door brand door is often a close relative of a Genie, and the parts line up. A Raynor door can have any opener on it, most often a LiftMaster, a Chamberlain or a Genie. We repair all of them.
Look on the inside of the door. Most makers put a label on one of the sections, on the end stile at the side, or on the track. It usually gives the brand and sometimes the model and the date. Mention it when you call, because it helps us bring the right parts.
If the label has faded or been painted over, that is fine. The section design, the hinges and the way the track is built usually tell the technician who made the door within a minute of looking at it.
For the opener, the label is on the motor unit on the ceiling, or on a wall-mounted unit beside the door. The brand on the opener and the brand on the door are often different, and that is normal.
Springs. Torsion springs are rated for a set number of open and close cycles, and they break when they reach it, often on a cold morning. The door suddenly weighs too much to lift and the opener strains or stops. That is a broken spring repair, and it is the most common call we get on any brand.
Cables and rollers. Lift cables fray at the bottom corners where water sits, and worn rollers make the door shake, grind or jump. A frayed cable is a warning, so it is worth getting a cable and roller repair before it lets go.
Sections. A car bumper, a ball or years of salt along the bottom can dent, crack or rust one section. When the maker still builds that design, the section can be replaced on its own. See garage door panel replacement.
Openers. An opener that hums but doesn't move, runs and stops, or ignores the remote has a specific cause. See garage door opener repair, or Genie opener repair if yours is an Overhead Door or Genie unit.
Both brands make commercial sectional doors and rolling steel doors, so we see them on auto shops, warehouses, garages under apartment buildings and loading docks. A commercial door opens many more times a day than a house door, so springs, rollers and bottom seals wear faster.
On a rolling steel door the springs sit inside the barrel above the opening, and the curtain is made of slats that can bend or pull out of the guides. Those are jobs for a technician with the right tools, because the barrel holds a lot of stored tension. Our commercial garage door repair page covers what we do for businesses.
For the door type itself, see rolling steel door repair, loading dock door repair and commercial door operators.
Most calls on these doors end in a repair. A spring, a cable or a set of rollers puts the door back to work, and the door itself has years left.
A new door starts to make sense when several sections are damaged or rusted through, when the design is no longer made and the damaged section can't be matched, or when the door was never insulated and the garage is now part of the living space. The technician tells you which side your door is on and why. If a new door is the better call, see new garage door installation.
The technician reads the labels, runs the door if it is safe to, and checks the balance, the springs, the cables, the rollers, the track and the opener. You hear what failed, what caused it, and what it takes to fix it. The estimate is free and no work starts until you say yes.
Common parts ride on the truck, so most repairs are done on the same visit. If a section or a specific part has to be ordered, you hear that up front. Before we leave, the door is run through several full cycles and the safety reverse is tested.
If the door is stuck open, won't close, or a spring has just broken, don't force it. Leave it where it is and call (929) 429-2429. A door that is out of balance can drop.
Yes. Raynor doors go up on the same kinds of springs, cables, rollers and tracks as other sectional doors, and we repair them on houses and on commercial buildings across Brooklyn, Queens and Long Island.
Yes. We repair Overhead Door brand doors and the openers that come with them. Overhead Door is the same company that owns Genie, so many of its openers share parts with Genie units.
Most doors carry a label on the inside of a section, on the end stile or on the track, with the maker's name. If the label is gone, the technician can usually tell from the hardware and the section design.
Often, yes, when the maker still builds that design and size. If it has been discontinued, you hear that on the first visit, along with the options, including a new door.
A door that suddenly feels heavy or lifts a few inches and stops usually has a broken spring or a slack cable. Leave it closed and call for a free estimate. Springs are a job for a technician.
Yes. The door gets looked at, you hear what failed and what it takes to fix it, and the estimate is free. No work starts until you say yes.
Describe the fault and we'll give you an honest arrival time. The visit and the estimate is free, anywhere in Brooklyn, Queens and Long Island.
Easier to explain by phone? Call (929) 429-2429.
Tell us what the door is doing. The estimate is free either way.