Serving Brooklyn, Queens and Long Island(929) 429-2429Open six days a weekFree estimateGuaranteed work
On Point Garage Doors
Open 24 hours Sun-Thu, Fri until 5 pm Free estimate Springs, openers, cables We come to you
Emergency?Call nowBook free estimate
New York, NY - open six days a week

Sliding gate installation

Free estimateSame-day serviceCommon parts on board
  • Free estimate
  • Same-day service
  • Common parts on board
Emergency garage door repair★★★★★ 5.0 on Google · 42 reviews

Book your free estimate

Takes 30 seconds. We call you back to set a time.

Or just call (929) 429-2429 and talk it through.

Home › Sliding Gate Installation

A sliding gate moves sideways along the fence line instead of swinging open, so it suits driveways that slope up toward the house, short driveways where a swing gate would hit the car, and parking lots where the gate has to open wide. Getting one right is mostly about the ground and the space: where the gate will slide to, what it will roll on and where the operator and its power will go. This page walks through the choices we go over at the estimate, so you know what to expect before a new sliding gate goes in. Free estimate at (929) 429-2429.

By Sean Cohen, owner, On Point Garage Doors · Updated

Real jobs. Real photos.

These photos are from our own jobs, with our logo on them.

Brick driveway at one of our jobs, from one of our jobs
Brick driveway at one of our jobs
Driveway gate between brick pillars, from one of our jobs
Driveway gate between brick pillars
Our truck at a gate job, from one of our jobs
Our truck at a gate job

Two ways a sliding gate moves

A track gate rolls on wheels along a steel rail set into or onto the driveway. A cantilever gate has no rail across the opening at all. It hangs on sets of rollers mounted on posts beside the opening and carries an extra tail section that counterbalances the part that spans the drive. Track gates are simpler to build. Cantilever gates keep the opening clear, which matters where snow, gravel or leaves would fill a track.

The space it needs

A sliding gate needs a clear run beside the opening at least as long as the gate itself. A cantilever gate needs more, because its tail section is roughly half as long again as the opening. That run has to be fairly level and free of trees, steps, meters and parked cars. On narrow city lots this is often the deciding question, and we measure it before talking about anything else.

The ground under it

For a track gate, the rail has to sit on solid, level concrete, or the wheels ride up and down and the motor works harder. Asphalt that cracks and settles is a poor base. For a cantilever gate, the posts that carry the rollers need deep, solid footings. We look at the slope, the drainage and the surface and tell you what has to be prepared before the gate arrives.

Choosing the gate

Steel gates are strong and suit lots and commercial yards. Aluminum gates are light, do not rust and are kind to the operator, which makes them a common pick near the water. Wood-clad gates match fences and houses but are heavier and need upkeep. Picket, solid and privacy styles all work as sliding gates. Lighter gates ask less of the motor and the rollers over the years.

The operator

Sliding gate operators sit on a concrete pad beside the opening and drive the gate with a toothed rack along its bottom rail or with a chain. They come in versions for homes and for heavy commercial use, and the choice depends on the gate weight and how often it runs. Many now have a battery inside so the gate still opens when the power goes out, and solar panels are an option where running power is hard.

Power and wiring

Most operators need power run to the pad and low voltage wire to any keypad, photo eyes and loops. Where the wire goes under a driveway, it goes in conduit. We plan the route at the estimate so nothing gets cut into the drive later than it has to be. If an electrician is needed for the power feed, we tell you that up front.

Safety comes with the gate

Getting in and out

How people open the gate is part of the plan. Remotes work for the household. A keypad suits deliveries and guests. An intercom or a phone entry system suits shared driveways and buildings, and phone control lets you open it from anywhere. A loop in the driveway can open the gate for cars leaving so nobody needs a remote to get out. We set up whichever mix fits how the property is used.

Replacing an old gate

If there is a gate already, we look at whether the posts, footings and operator can stay. Sometimes a new gate leaf goes onto existing rollers and a new operator, and sometimes the old track and posts have moved too far and start over is the better choice. The old gate and parts go away with us.

Install day

Once the base is ready, the gate goes onto its track or rollers, the operator is set on its pad and the rack or chain is lined up along the gate. Then the limits, force and speed are set, the safety devices are wired and tested, and the controls are paired. Before we leave, we show you how the gate works, how to use the manual release and what the beeps or lights on the operator mean.

Looking after it

A sliding gate stays reliable when its track is kept clear, its rollers turn freely and its safety devices are tested. Our page on sliding gate repair covers what wears out over the years, and a yearly look keeps small problems small.

Questions we get asked

Which is better, a track gate or a cantilever gate?

A cantilever gate keeps the driveway clear of rails, which helps with snow and debris. A track gate needs less room beside the opening. The space you have usually decides.

How much room does a sliding gate need beside the driveway?

At least the length of the gate, and more for a cantilever gate because of its tail section. We measure it at the estimate.

Will the gate open if the power goes out?

Many operators have a battery inside that keeps the gate running for a while, and every gate has a manual release.

Can you add a keypad or intercom?

Yes. Remotes, keypads, intercoms, phone control and exit loops can all be set up with the gate.

Is the estimate free?

Yes. We measure the opening and the run beside it and go over the options with you.

Booking takes a minute

Across Brooklyn, Queens and Long Island, tell us what the door is doing and we set a visit that fits your day.

Free estimate, call (929) 429-2429.

Planning a sliding gate? Tell us about the driveway

Tell us what the door is doing and we will give you an honest arrival time. The estimate is free.

Easier to explain by phone? Call (929) 429-2429.

Two minutes to a free estimate

Tell us what the door is doing. The estimate is free either way.

Or just call (929) 429-2429 and talk it through.

The other six things that go wrong