
Takes 30 seconds. We call you back to set a time.
A dent in a garage door usually comes from a car bumper, a ball, a bike or a storm. Some dents are only cosmetic. Others bend the section enough to strain the hinges, twist the door in its tracks or crack the struts. The good news is that on most sectional doors a single damaged section can be replaced without changing the whole door. Free estimate at (929) 429-2429.
By Sean Cohen, owner, On Point Garage Doors · Updated
These photos are from our own jobs, with our logo on them.



If a car hit the door, leave it where it is. Running a bent door can tear the cables off the bottom brackets or push it out of the tracks. Keep people and pets away from it and call.
Take a photo of the damage and the inside of the door if you can see it. It helps the technician bring the right parts.
Sectional doors are built from separate panels, so the damaged one can often be ordered to match and swapped in. The hinges, rollers and struts on that section are replaced at the same time.
On older doors, the exact panel may no longer be made. In that case the technician tells you plainly and explains the options, including a new door.
Then the door is run through its full travel and the safety reverse tested.
The bottom section takes the most bumps from bumpers, bikes and snow blowers, and it also carries the bottom seal and the cable brackets. A dented bottom section is replaced with a new seal.
If rust has started at the dent, it spreads faster, so the bottom section is worth replacing early.
Many dents come from a door that stops short or closes on the car. Properly set sensors and limits, a clear space in front of the door and a parking guide on the floor or wall prevent a lot of them.
Insulated and heavier-gauge doors also resist dents better than thin single-layer steel.
If several sections are dented or rusted, the door is old, or matching panels are no longer available, a new door is often the better value over time. You get the options side by side, with a free estimate for each.
Strong wind can push a wide door in at the middle and crease several sections at once. Flying debris and hail leave dents across the face.
After a storm, the technician checks the struts, tracks and brackets as well as the panels, because wind load often bends the hardware that holds the door straight.
When one section is replaced, it should match the rest of the door in style, color and finish. Most common steel styles are easy to match. On a Clopay, the label inside the door names the series to order, and our Clopay door repair page explains how a matching section is chosen.
On older or discontinued doors, a close match is not always possible, and the technician tells you that before anything is ordered.
On an insulated door, a deep dent can crush the foam inside the section and leave a cold spot. The section still works, but it loses some of its insulation and strength.
If the garage is heated or sits under living space, replacing the dented section restores both the look and the insulation.
Most dents we see come from the household's own car: backing out before the door is fully up, or pulling in a little too far. Kids' balls, bikes and snow blowers come next.
The damaged section and its neighbors are checked, along with the hinges, struts, tracks, cables and springs. You see the options, one section or a new door, with a free estimate for each, before anything is ordered.
On most sectional doors, yes, if a matching panel is still available. The hinges and rollers on that section are replaced too.
If the door runs normally, a small dent is usually cosmetic. If it binds, looks crooked or was hit while moving, do not run it until it is checked.
The dent may have bent a hinge or pushed a roller out of line, or the track may be bent. The door binds and the opener stops.
Yes. Insulated doors with two layers of steel are much stiffer than thin single-layer doors.
Yes. You hear whether a section or a new door makes more sense before any work starts.
Across Brooklyn, Queens and Long Island, tell us what the door is doing and we set a visit that fits your day.
Free estimate, call (929) 429-2429.
Tell us what the door is doing and we will give you an honest arrival time. The estimate is free.
Easier to explain by phone? Call (929) 429-2429.
Tell us what the door is doing. The estimate is free either way.